User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 6 - Performing System Upgrades
Concentrator User and Installation Guide 98-1031 Rev AA 55
3. Type iscellnet.
Figure 6 - 2. iscellnet screen shot
If the ping is successful, the system returns the length of time it took to receive a response. If the
ping is unsuccessful, the system indicates a time out condition.
Hot-Booting a Concentrator
Always perform a disconnect, followed by a hot boot, before any download operations. For a
firmware upgrade to be successful, it must load on top of system variables set to their default values.
If you always perform a hot reboot, you always start with default values.
1. Open a command window on your PC.
2. Use your administrative credentials to login as control user.
3. Type mcc_cmd 30000.1 -resethot.
Figure 6 - 3. Hot boot concentrator