User's Manual

1-Way Repeater Setup
97-1077 rev AB Page 5 of 11
PROPRIETARY INFORMATION NOTICE:
THIS DOCUMENT CONTAINS TRADE SECRETS AND CONFIDENTIAL INFORMATION OF CELLNET AND SHALL NOT
BE DUPLICATED IN WHOLE OR IN PART OR USED OR DISCLOSED FOR ANY PURPOSE OTHER THAN THAT
APPROVED BY CELLNET.
© Cellnet 2008. All rights reserved.
Page 5 of 11
MCC Setup
The following commands are needed to set up the receiving MCC. The settings of the
MCC processor board need to be changed. Changing the settings in the BLT radio alone
will not result in permanent changes and the processor will change the BLT back to the
original settings. Note that this MCC will only receive from 1-Way Repeaters because it
will only receive at 911.58 MHz.
In order to set up the MCC, follow the following instructions. Entries are shown in red.
Connect to the MCC using Hyperterm or MCC Term if the GUI features are not used.
Type <unlock>
Console unlocked...
MCC Main Menu
i Display firmware version info
t CellNet Time and Real Time Clock (RTC) menu...
a Application menu...
c Configuration (EEPROM) menu...
d Debug menu...
l Lock Console
m Toggle Terse Mode
Select option (? for menu): c
MCC860 EEPROM Configuration Menu
d Display all configuration items a page at a time
x Display all configuration items with no paging
D Display only new items
s Set specific items (choose from paged list)
n Set specific items by name or id number
a Interactively set all items (prompt for each one)
A Interactively set new items
e Interactively set all out-of-range items
E Interactively set out-of-range new items
r Set all items to defaults (no prompting)
R Set new items to defaults