User's Manual

1-Way Repeater Setup
97-1077 rev AB Page 4 of 11
PROPRIETARY INFORMATION NOTICE:
THIS DOCUMENT CONTAINS TRADE SECRETS AND CONFIDENTIAL INFORMATION OF CELLNET AND SHALL NOT
BE DUPLICATED IN WHOLE OR IN PART OR USED OR DISCLOSED FOR ANY PURPOSE OTHER THAN THAT
APPROVED BY CELLNET.
© Cellnet 2008. All rights reserved.
Page 4 of 11
Installation
The 1-Way Repeater is packaged with two antennas and two ground disks. A mounting
kit is available that contains the mounting kit to install the radio and the RF cables to the
antennas. This installation is similar to other Cellnet products. The repeater is attached to
the streetlight arm and powered via the streetlight photocell adapter cable ordered with
the repeater. No additional SW or configuration is required.
Equipment Required
• 45-1049: mounting kit that can be used with one way repeater. Antennas and antenna
ground disk supplied with 1-Way Repeater
•
Recommended torque settings for ¼” HW: 45 in-lb
• Serial cable: None expected to be used in normal operation
• 103826-000: AC power cable if attached to photocell, other installations possible
Note: Professional installation of the 1-Way Repeater is required.
Low Density Deployment
The 1-Way Repeater could be used to include a rural group of meters currently read by
manual means. This allows network costs to be reduced.