User's Manual

1-Way Repeater Setup
97-1077 rev AB Page 11 of 11
PROPRIETARY INFORMATION NOTICE:
THIS DOCUMENT CONTAINS TRADE SECRETS AND CONFIDENTIAL INFORMATION OF CELLNET AND SHALL NOT
BE DUPLICATED IN WHOLE OR IN PART OR USED OR DISCLOSED FOR ANY PURPOSE OTHER THAN THAT
APPROVED BY CELLNET.
© Cellnet 2008. All rights reserved.
Page 11 of 11
“To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.”
“This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3 dBi. Antennas not included in this list or having a gain
greater than 3 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.”
Equipment manufacturers shall provide proper values of antenna gain and antenna
impedance to comply with the applicable RSS.
Cellnet provides an antenna with the 26-1146 1-Way Repeater and recommends that this
antenna be used when the 1-Way Repeater is installed.
Antennas approved for use with this product:
01-1239 ANTENNA,3dB GAIN,ASPG918