User's Manual

SOP Utilinet Concentrator Installation
XX-XXXX, Rev: 01
Page 10 of 18
© Cellnet 2006. All rights reserved.
Maximum Effective Isotropic Radiated Power (EIRP), +36 dBm, established by the FCC. User
must adjust the power output and select the antenna gain to comply with this requirement.
Industry Canada:
This device has been designed to operate with the antennas listed above, and having a maximum
gain of 6 dBi. Antennas not included in this list or having a gain greater than 6 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.
1.3 Concentrator programming
Programming of the Concentrator is required prior to installation. The Concentrator programming
process consists of entering GPS and other required parameters into the radio. This task is best
done in batch mode where the Concentrators are stored prior to field deployment for installation.
For the purposes of this SOP, it is assumed that the programming has already been completed
and the information provided with work order/installation sheet. The Concentrator will typically be
labeled with the IPC address visible from the outside.
2.0 Required Tools & Materials
The following is a list of tools and materials for installing the Concentrators for utility pole and
streetlight mounting. For building and pad-mount installations, the same tools will apply with
some additional materials required. Check under the type of installation for materials and tools
needed to perform the installation.
Material Provided by Cellnet
Wood Utility
Pole
Steel Street
Light Pole
Building & Structure
Install
Pad-mount
XFMR
Concentrators (Concentrators)
X X X X
LAN omni whip antennas
X X X X
WAN omni whip antenna
X X X X
Streetlight head adapter
X
RF coaxial cables**
X X X X
AC power quick disconnect
connector with 8 ft. or 18 ft. wire
attached
X X X X
Female N – bulkhead connectors
X X X
MCC strap mounting brackets
X
** These come in different lengths, 5, 10, 15, 20, and 25, are most commonly used