User Manual

Data Sheet Landis+Gyr
6 98-1083 Rev AA Data Sheet
1. LAN ID, includes programmed module part number (printed and barcoded)
2. Product ID (printed and barcoded)
3. FCC ID:TEB-HUNTGS10122
4. ICC ID: 5931A- HUNTGS10122
Features and Functions
Using the GE High Speed kV2c Meter with the Gridstream RF kV2c Enhanced endpoint, you can:
• Integrate the endpoint into all forms, classes and voltages of the GE kV2c meter.
• Communicate via serial connection between the endpoint and the meter through the meter's
provided interface.
• Support all levels of meter passwords.
• Download radio firmware.
AMR Interface
The integrated connection contains:
• Three-wire, bi-directional serial interface
• Baud rate is 9600, 8 bits, 1 stop bit, no hardware hand-shaking.
• Power fail indication signal from the meter that tells the endpoint to disconnect from
drawing power from the meter.
• DC power line which supplies power to the module from the meter.
Registration
Endpoint firmware version XXX or later and module Device Control Word (DCW) XXX or later is
required for auto-registration. After the meter/endpoint is installed in the field it will automatically
register with the Head End System. No special tools are needed during installation as the normal
Utility meter swap process can be utilized.
The meter automatically sends in the registration information containing items on how the meter/
endpoint is configured so the host can properly interpret the incoming data. Some of the items
contained in this are as follows:
• Default Gridstream RF Collector destination
• Reporting interval for Register Data
• Reporting interval for Interval Data
• Meter's AMR-level security password
• Time Synchronization parameters
• GMT offset
• Periodic Register Data reporting
• Periodic LP Data reporting