User Manual

Landis+Gyr Data Sheet

Data Sheet 98-1083 Rev AA 5

RF Interference

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the meter off, the user is encouraged to try to correct the interference by one

or more of the following measures:

1. Re-orient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Consult Landis+Gyr or an experienced radio/TC technician for help.

Required Software

To work with the endpoint, you need one of the following software tools:

• Command Center version 5.5 or later.

• RadioShop version XX or later

• Endpoint Testing Manager version XX or later

About the LAN ID

The LAN ID is a unique identifier for each endpoint. It always displays in hex. Landis+Gyr provides

the LAN address. You cannot change the LAN ID of a radio.

Labels

The endpoint includes the following labels.

Figure 2. Label Identification

MODEL 40-6100

XXXXXXXX

GE #103X942001 ww/yy

40-6100

REV XX

MODEL 40-6101

XXXXXXXX

GE #103X942001 ww/yy

40-6101

REV XX