User Manual

Data Sheet Landis+Gyr
4 98-1083 Rev AA Data Sheet
FCC Compliance Information
Model: 40-6100 (Forms 1S, 2S, 9S, 12S, 16S, 45S)
FCC ID:TEB-HUNTGS10122
Module: 10122
Industry Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Cet appareillage numérique de la classe B répond à toutes les exigences de l'interférence canadienne
causant des règlements d'équipement. L'opération est sujette aux deux conditions suivantes: (1) ce
dispositif peut ne pas causer l'interférence nocive, et (2) ce dispositif doit accepter n'importe quelle
interférence reçue, y compris l'interférence qui peut causer l'opération peu désirée.
Pour réduire le risque d'interférer avec d'autres utilisateurs, le type d'antenne et son gain doivent être
choisis de telle sorte que la Puissance Isotrope Rayonnée Equivalente (P.I.R.E) ne soit pas supérieure
à celle autorisée pour une communication réussie.
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
U WARNING: Changes or modifications not expressly approved by Landis+Gyr for compliance
could void the user’s authority to operate the equipment.
Endpoint Location
To comply with FCC’s RF exposure limits for general population/uncontrolled exposure, the
antenna(e) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be collocated or operating in conjunction with any other antenna or
transmitter.
Endpoint Usage
The Gridstream RF FOCUS AX Integrated endpoint will be used for residential and light
commercial metering applications.
The Gridstream RF FOCUS AX Integrated endpoint requires professional installation by qualified
personnel.