Operation Manual

Seat belts
27
Caring for seat belts
Regularly inspect the belt webbing for signs of
wear, paying particular attention to the fixing
points and adjusters. Always replace a seat
belt that has withstood the strain of an impact
or shows signs of fraying.
DO NOT bleach or dye the webbing. Clean the
webbing using warm water and non-detergent
soap only - allow to dry naturally and DO NOT
retract the belt until completely dry.
Testing inertia reel belts
From time to time carry out the following
tests:
1. With the seat belt fastened, give the
webbing near the buckle a quick upward
pull. The buckle must remain securely
locked.
2. With the seat belt unfastened, unreel the
webbing to the limit of its travel. Check
that unreeling is free from snatches and
snags.
3. With the webbing half unreeled, hold the
tongue plate and give it a quick forward
pull. The safety mechanism must lock
automatically and prevent any further
unreeling.