Operation Manual

Workshop maintenance
130
Undertray removal
Rear section:
The rear undertray (1) can be removed to
enable access to the gearbox drain and filler
level plugs.
• Raise the vehicle on a ramp.
• Remove the two bolts (2) securing the
rear and front undertray together.
• Remove the two bolts (3) securing the
rear undertray to the chassis
crossmember.
• Remove the bolt (4) securing the
undertray to the right hand side of the
chassis.
• Pull the undertray rearwards to disengage
from the front undertray and remove.
Refitting the undertray is the reverse of the
removal procedure, but take care to ensure
that the flanges of the front undertray are
properly located. Tighten the bolts (2, 3, & 4)
to a torque rating of 14 Nm (10 lbf/ft).