Operation Manual

Wheel changing
109
Operating the pillar jack (if supplied)
For any wheel:
1. Remove the rubber plug (1) from the
jacking tube corresponding to the wheel to
be changed.
2. Insert the jack pillar into the base (2).
3. Fit the handle (3) to the pillar and adjust
the height so the jacking peg (4) can be
inserted into the jacking tube.
NOTE: The jack handle operatesas a ratchet -
one side raisesthe jack, then turn the handle
over to lower the jack.
WARNING
ENSURE that you are familiar with operating
the jack BEFORE using it to raise a vehicle.
ONLY jack the vehicle using the jack
location points described or personal injury
or damage to the vehicle could occur.
DO NOT use the jack without the base fitted -
the vehicle would not be properly supported
and could cause personal injury.
ENSURE that the peg is FULLY engaged in
the jacking tube.
ENSURE that the pillar is vertical NOT at an
angle.