Operation Manual
Tyres
98
WARNING
Never drive your vehicle if the tyres are
badly worn, cut or damaged, or if the
pressures are incorrect.
Incorrectly inflated tyres wear rapidly and
seriously affect the vehicle’s safety and road
handling characteristics.
Caring for your tyres
Always drive with consideration for the
condition of the tyres and frequently inspect
the tread and side walls for signs of distortion
or damage (in particular, look for lumps, cuts
and bulges).
Tyre pressures
Tyre pressures should be checked at least
once a week with normal road use, but should
be checked DAILY if the vehicle is used
off-road.
Check the pressures - including the spare -
when the tyres are cold (air pressure naturally
increases in warm tyres). The recommended
pressures are shown in ’General data’.
WARNING
If the vehicle has been parked in strong
sunlight or is used in high ambient
temperatures, DO NOT reduce tyre
pressures; instead, move the vehicle into
shade and allow the tyres to cool before
checking.
Tyre wear
Some tyres fitted as original equipment have
wear indicators moulded into the tread
pattern. When the tread has worn down to 1.6
mm (1/16 in) the indicators start appearing at
the surface of the tread pattern, producing the
effect of a continuous band of rubber across
the width of the tyre.
A tyre MUST be replaced as soon as an
indicator band becomes visible or the tread
depth reaches the minimum permitted by
legislation.
Tread depth must be checked regularly (at
every maintenance service, or more
frequently). Always replace a tyre before the
tread reaches a remaining depth of 1.6 mm
(1/16 in). DO NOT drive with tyres worn to
this limit, the safety of the vehicle and its
occupants will be adversely affected.
NOTE: After off-road use, check to make sure
there are no lumps or bulges in the tyres or
exposure of the ply or cord structure.
Valve caps
Keep the valve caps screwed down firmly to
prevent dirt from entering the valve.
Replacement tyres
Wheel rims and tyres are matched to suit the
handling characteristics of the vehicle. For
safety, ALWAYS check that replacement tyres
comply with the manufacturer’s original
specification and that the load rating shown
on the side wall is the same as that of the
original equipment for a particular territory.
Contact your Land Rover dealer for further
information or assistance.