All Purpose Seedeer Operator's Manual

Section 3: Adjustments

5/13/08

APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M

Land Pride

Table of Contents

Drive Chain Engagement

Refer to Figure 3-3:

Soil that is very hard or with a lot of unwanted vegetation

may require several passes with the front rollers set at a

very aggressive angle before planting begins.

Disengage drive chain from the rear roller while making

these passes and engage drive chain when ready to start

planting seed.

1. Lower seeder frame onto blocks supporting rear

roller just above ground level to allow roller to turn

freely.

2. Shut tractor engine off and engage parking brake.

3. Remove drive guard (not shown).

4. Remove wire retaining pin (#1) from drive

sprocket (#2). Store retaining pin for reuse.

5. Replace drive guard.

6. Remove support blocks and lower seeder to ground.

NOTE: If needed, set front roller angle before

lowering seeder to ground level. See Front Roller

Angle Adjustment on this page.

Disengage Drive Chain

Figure 3-3

24938