Operation Manual

LANCOM IAP-54 Wireless - LANCOM XAP-40-2 - LANCOM XAC-40-1
 Chapter 2: Installation
19
EN
 First 10/100Base-Tx ethernet connector for connection to the LAN.
 Second ethernet connector.
Both 10 Mbps or 100 Mbps connections are supported. The available
transfer rate is detected automatically (autosensing). The LAN connection
features an automatic MDI/MDIX detector omitting the use of cross-over
cables.
The LAN connector on the LANCOM access point supports the Power over
Ethernet standard IEEE 802.3af (PoE). Further information about the
operations with PoE can be found in the information box 'Power over
Ethernet—elegant power supply over LAN cabling'.
By activated DSLoL option, the LAN connector can also be used for
connecting the access point to a broadband modem.
 Reset button (see "Reset button functions")
 Serial configuration port
 Aux connector for second WLAN modul.
 Aux connector for first WLAN modul.
 Connection for the included power adapter
 Connection for 24 V DC via 4-pin plug (Phoenix Contact, Combicon RM
3,81mm). Two 24 V voltage sources can be connected to the redundant
power supply.

The 24 V input in particular has been optimized for industrial settings.
Variation of the input voltage between 20 V to 28 V can be tolerated.
Reset button functions
The reset button offers two basic functions—boot (restart) and reset (to the
factory settings)—which are called by pressing the button for different
lengths of time.
Some devices simply cannot be installed under lock and key. There is
consequently a risk that the configuration will be deleted by mistake of a co-