Operation Manual

Operating modes and functions
ELSA LANCOM Wireless
34
English
Script
The script list in the ELSA LANconfig can be found in the 'Communication' configuration
section on the 'Protocols' tab, or under
/Setup/WAN-module/Script List
during telnet or terminal sessions.
If the processing of a script is required to connect to a remote station, enter the script
here and assign it to a remote station.
The layer-3 protocol selected in the layer list for this connection must support scripting.
쮿
Remote site
Name of the remote station as specified before in the name list.
쮿
Script
Enter the script here as described in the reference section of the documentation.
Call acceptance
The call acceptance settings for the ELSA LANconfig can be found in the
'Communication' configuration section on the 'Call Acceptance' tab, or under
/Setup/
WAN-module/Security
during telnet or terminal sessions.
Use the call-acceptance settings to determine the circumstances under which the unit
will accept incoming calls. These settings only apply to the unit's router functions.
쮿
All
Every call is accepted.
쮿
Name
Every call is accepted at first. During the protocol negotiation the name is
determined and checked against the name list. The connection is maintained if the
name is present, otherwise it will be rejected.
쮿
Number
The call will only be accepted if the remote station is entered in the number list and
the number is transferred to the remote station.
쮿
Name or number
The call will be accepted if one of the two checks was successful.
Number-list
The number list in the ELSA LANconfig can be found in the 'Communication'
configuration section on the 'Call Acceptance' tab, or under
/Setup/WAN-module/
Number List
during telnet or terminal sessions.
The number list is used as a call acceptance control measure during passive call
establishment and to initiate callbacks.