Operation Manual

Operating modes and functions
ELSA LANCOM Wireless
32
English
Normally the number specified in the CAPI application is transferred to the remote
station via the
LANCAPI during active call establishment. No number is transferred
by the
LANCAPI if this number has not been specified or the number is invalid. This
option lets you transfer the first number entered in the 'Subscriber Number' field if
no number has been specified in the CAPI application.
Layer list
The list of communications layers in the ELSA LANconfig can be found in the
'Communication' configuration section on the 'General' tab, or under
/Setup/WAN-
module/Layer List
during telnet or terminal sessions.
A layer defines a specific combination of protocol settings to be used for data transfer to
other devices. Specifically, they are:
쮿
WAN-layer
The protocol settings will be saved under this name. In the name list, select the
settings with the layer name for the appropriate connection.
쮿
Encapsulation
Specify here whether an Ethernet header should be added to the data packets.
Normally the setting 'Transparent' will be sufficient; this setting may only be
required for HDLC connections to third-party devices.
쮿
Layer-3
Layer-3 protocol for the connection. Recognized automatically in the case of some
incoming connections.
An additional entry is required in the PPP list when using PPP.
An additional entry is required in the scripts list when using scripts.
쮿
Layer-2
Layer-2 protocol for the connection.
쮿
Options
Enables data compression and channel bundling. This option is only effective when
supported by the protocols of Layer 2 and Layer 3.
쮿
Layer-1
Layer-1 protocol for the connection. Recognized automatically in the case of some
incoming connections.