Operation Manual
Operating modes and functions
ELSA LANCOM Wireless
31
English
Router interface settings
The router interface settings for the
ELSA LANconfig
can be found in the
'Communication' configuration section on the 'General' tab, or under
/Setup/WAN-
module/Router Interface List
during telnet or terminal sessions.
The router interface settings determine the parameters to be used for each interface (i.e.
each S
0
port) while in router mode. These parameters do not apply to the other operating
modes of the units. Specifically, they are:
쮿
Subscriber numbers (MSN/terminal device selection numbers)
The router responds to incoming calls for these numbers. Multiple numbers are
separated by semicolons. If no number is specified, the router will respond to all
incoming calls.
The first number specified will be transmitted to the remote station during the active
establishment of a connection. If no number is specified, the main MSN of the
connection will be transmitted.
쮿
Option for Y connections
Enable this option if it should be possible for both B channels of the connection to
establish parallel connections to different remote stations.
쮿
Suppression of own subscriber number
Enable this option in order to suppress the display of your own subscriber number to
the remote station during call establishment.
This function must be supported by the network operator.
LANCAPI
interface settings
The
LANCAPI
interface settings for the
ELSA LANconfig
can be found in the 'LANCAPI'
configuration section on the 'General' tab, or under
/Setup/LANCAPI-module/
Interface List
during telnet or terminal sessions.
Use the router interface settings to determine the parameters to be used for each
interface (i.e. each S
0
port) for the
LANCAPI
. These parameters do not apply to the other
operating modes of the units. Specifically, they are:
쮿
Subscriber numbers (MSN/terminal device selection numbers)
The
LANCAPI
responds to incoming calls for these numbers. Multiple numbers are
separated by semicolons. If no number is specified, the router will respond to all
incoming calls.
쮿
Access to
LANCAPI
Here you can completely disable the
LANCAPI
functions for the interface, or enable
it only for incoming or outgoing calls.
쮿
Transfer of own subscriber number