Operation Manual

Installation
ELSA LANCOM Wireless
16
English
– You have previously used IP addresses for the computers in your LAN. Assign a
free address from the previously used address range to the access point and
specify whether the access point should act as a DHCP server.
Further information on the structure of networks in general and IP addressing can be
found in the electronic documentation on the ELSA LANCOM Wireless CD. The functions
of the DHCP server are described later in this manual.
햵
That was it—your access point is now ready for its basic task, providing mobile
stations access to a wired LAN.
Configuring the basic settings using Telnet
If you do not want to use ELSA LANconfig , or cannot use it because you are using a
different operating system for example, you can set up the basic configuration using a
Telnet connection.
Open a Telnet connection to the address '10.0.0.254' if you have not used IP addresses
in your network to date, or the address 'x.x.x.254', in which 'x.x.x' stands for the address
range previously used in the network.
Enter the following command:
햲
Start the Telnet connection by clicking
Start
왘
Run
and entering
Telnet
10.0.0.254
on the command line.
햳
To change the language for the configuration, enter:
set /Setup/config-module/language english
햴
Intranet address and network mask:
set /setup/TCP-IP-module/ Intranet adr. 10.0.0.1
set
/setup/TCP-IP-module/ Intranet mask 255.255.255.0.
You may have to reboot the router after changing the Intranet address.
햵
To switch off the DHCP function:
set setup/DHCP-module/operating off