Operation Manual

Installation
ELSA LANCOM Wireless
12
English
LEDs
You will find a number of LEDs as display elements on the front panel.

The red LED of the wireless network adapter indicates that a connection has been
established between the card and access point.

The yellow LED of the wireless network adapter indicates the number of mobile
stations logged onto the access point. For example, when three stations are logged
on, the LED flashes three times in quick succession before pausing briefly.

The green LED of the wireless network adapter indicates activity on the wireless
network, in other words the sending and receiving that data is being sent and
received. If this LED does not light up at all or remains lit permanently, this indicates
a fault in the wireless network adapter.

The 'Power/Msg' LED on the access point lights up briefly when the power is
switched on. After the self-test, either an error is output by a flashing light code or
the device starts and the LED remains lit.

The 'S
0
Status' LED on the access point shows the activity on the D channel.
쐏쐄 쐊
쐎
쐂쐆
쐃
쐇
쐋
off Device off
green 1 x short Boot procedure (test and load) started
green flashing Display of a boot error (flashing light code)
green Device ready for use