Operation Manual

Description of the menu options
ELSA LANCOM Wireless
R71
English
In principle, any SNMP manager can use this command to obtain information from the
router. The syntax
register-monitor IP-address:port mac address timeout
is used to direct the router to enter the given address in the monitor table and to send
traps to it. If the traps are not received within the set hold time, the address will be
automatically deleted from the table. A hold time of '0' permanently retains the entry in
the table.
Delete-monitor
This command removes the entries from the monitor table.
Monitor-table
The monitor table has the following structure:
This entry indicates, for example, that an
ELSA LANmonitor
has logged on to the router.
Setup/DHCP-server-module
This menu allows you to enter settings for the DHCP server. The menu has the following
layout:
State
On: The device operates as a DHCP server
Off: The device does not operate as a DHCP server
Auto: The device regularly checks whether there is another DHCP server in the LAN. If
not, it operates as a DHCP server and issues IP addresses to local clients.
IP-address Port MAC-address Timeout
10.0.0.53 1057 0080c76da46e 1
/DHCP-server-module DHCP server settings
State Switch for activating the DHCP module
Start-address-pool Start address for the address pool
End-address-pool End address for the address pool
Netmask Network mask for the address pool
Broadcast-address Broadcast address for the LAN
Gateway-address Gateway-address for the LAN
Max.-lease-time-minute(s) Maximum period of validity for the address assignment
via DHCP
Default-lease-time-minute(s) Default period of validity for the address assignment via
DHCP
Table-DHCP Table of current assignments via DHCP