Operation Manual

•
129
LANCOM Advanced VoIP Client
 LANCOM Advanced VoIP Client Configuration
This is how you define the properties of the Caller List and Redial
햲
Enter the maximum number of entries to be included in the Caller List in the
field “Maximum length” located under “Caller List”.
If this length limitation is exceeded, the oldest entry in the list will be deleted.
햳 Enter the maximum number of entries to be included in the Redial List in the
field “Maximum length” located under “Redial List”.
햴 Select the check box “Dial immediately” if the number or subscriber selected
should be dialed immediately.
If this option is deactivated, you can still change the telephone number before
the actual dialing procedure takes place.
햵 Under “Automatic Redial”, activate the option “Always use automatic redial”, if
you would like to directly initiate the Automatic Redial of the last number using
the Redial button.
햶 If this option is deactivated, only a single Redial of the number dialed last will
be started.
햷 Click on “OK”.
Configure Caller
List and Redial
Fig. 3 List Settings