System information

LANCOM ES-2126+ und LANCOM ES-2126P

쮿 Chapter 4: Operation of Web- based Management

쮿 Function Description: It is used to set each port’s operation mode. The

switch supports 3 parameters for each port. They are State, Speed/Duplex

and Flow Control.

쮿 Parameter Description:

왏 State: Set the communication capability of the port is Enabled or

Disabled. When enabled, traffic can be transmitted and received via

this port. When disabled, the port is blocked and no traffic can be

transferred through this port. Port State is configurable by the user.

There are only two states “Enable” and “Disable” able to choose. If

you set a port’s state “Disable”, then that port is prohibited to pass

any traffic, even it looks Link up.

Default: Enable.

왏 Speed/Duplex: Set the speed and duplex of the port. In speed, 10/

100Mbps baud rate is available for Fast Ethernet, Gigabit module in

port 25, 26. If the media is 1Gbps fiber, it is always 1000Mbps and

the duplex is full only. If the media is TP, the Speed/Duplex is compri-

sed of the combination of speed mode, 10/100/1000Mbps, and dup-

lex mode, full duplex and half duplex. The following table summarized

the function the media supports.

In Auto-negotiation mode, no default value. In Forced mode, default

value depends on your setting.

왏 Flow Control: There are two modes to choose in flow control, inclu-

ding Symmetric and Asymmetric. If flow control is set Symmetric, both

parties can send PAUSE frame to the transmitting device(s) if the

receiving port is too busy to handle. When it is set Asymmetric, this

will let the receiving port care the PAUSE frame from transmitting

device(s), but it doesn’t send PAUSE frame. This is one-way flow con-

trol.

Default: Symmetric.

Media type NWay Speed Duplex

100M TP ON/OFF 10/100M Full/Half

1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100

1000M Fiber ON/OFF 1000M Full