System information

LANCOM ES-2126+ und LANCOM ES-2126P
쮿 Chapter 2: Installation
16
EN
쐋 PWR
Power LED: Constant green when power is supplied to the device.
쐏
ACT
Constant green when the LED mode is set to "Active".
쐄
FDX
Constant green when the LED mode is set to "Full-Duplex".
쐂
SPD
Constant green when the LED mode is set to "Speed".
쐆
LEDSET
Button to switch the LEDmode between -“Active”, “Full-Duplex” and “Speed”.
쐊
LINK
Port 1 to 24
Constant green when the network connection is established to the connected
device. Off if no network connection can be established to the connected
device.
쐎
ACT/FDX/SPD
Port 1 to 24
This LED displays the following information depending on the selected LED
status:
쮿 LED mode “Active”: Blinks yellow during data transfer.
쮿 LED mode “Full-Duplex”: Constant green when full-duplex mode is active
for this port; blinks yellow in case of collisions.
쮿 LED mode “Speed”: Constant yellow when the 100 Mbps mode is active.
Off when the 10 Mbps mode is active.
쐅
Link
Port 25 and 26
Constant green when the network connection is established to the connected
device. Off if no network connection can be established to the connected
device.
쐈
FB
Port 25 and 26
Constant green when the optical port is active. Off when the TP port is active
쐉
ACT
Port 25 and 26
This LED displays the following information depending on the selected LED
status:
쮿 LED mode “Active”: Blinks yellow during data transfer.
쮿 LED mode “Full-Duplex”: Constant green when full-duplex mode is active
for this port; blinks yellow in case of collisions.
쮿 LED mode “Speed”: Constant green when the Gbps mode is active. Off
when the 10 Mbps or 100 Mbps mode is active.
2.3.2 LEDs and buttons on the LANCOM ES-2126P
Located on the front of the device are light-emitting diodes (LEDs) that pro-
vide information on device status, and also two buttons.