Instructions / Assembly

RECOMMENDED EQUIPMENT: Use airless pump with pressures of 1500-2000 PSI. A fluid delivery of 1-2
gallons per minute with a spray tip size of .026 - .035 will be adequate. The hoses should be at least 3/8" inside
diameter, and should be of the high pressure rated type. If the hose length is more than 50 feet, a larger
inside diameter will be required.
COVERAGE: PRODUCT MUST BE APPLIED AT 50 SQ.FT/GAL. IN AT LEAST TWO (2) COATS 24 HOURS APART
FOR A MINIMUM FILM THICKNESS OF 32 MILS DRY (About the thickness of 12 sheets of paper). Find your
square footage by multiplying the length of an area by the width of that area (i.e. 10 X 100 = 1000 sq. ft.
divided by 50 sq. ft. = 20 X 2 COATS = 40 Gallons of product). Apply the first coat by pouring coating onto roof
and spreading it at a rate of 50 sq.ft/gal. (32 mils wet). Avoid going twice over the same area. Allow 24 hours
before applying subsequent coats applying them in the same manner as the first coat. A MINIMUM OF 2
COATS IS REQUIRED WITH A FILM THICKNESS OF 32 MILS DRY.
Steeper pitched roofs will require more applications if 50 SQ.FT/GAL. cannot be achieved.
CLEAN-UP: Clean rollers or equipment after use with warm, soapy water.
DRYING TIME: Approximately 2 – 4 hours. Cure time is controlled by thickness of the applied coating, relative
humidity and temperature. Allow 24 hours dry time between coats.
WARRANTY:
*10 YEARS WARRANTY: Limited Warranty: Lanco Manufacturing Corporation (LANCO®) warrants only that this
product is free of defects, since many factors which affects the results obtained from this product (such as
weather, workmanship, equipment used and prior conditions of substrate) are beyond our control. We will
replace at no charge any product proven to be defective within 10 years of purchase, provided it has been
applied per manufacturer’s specifications. To take effect, this warranty must be activated by mailing proof of
purchase, name and address to the following address: (For USA) Lanco, 600 Mid Florida Drive Airport
Industrial Park of Orlando, Florida 32824, and following the registration procedure. (For the Caribbean) Lanco,
Urb. Aponte #5 San Lorenzo, P.R. 000754. This warranty is non-transferable. To file a claim under this warranty
you must send a notice of claim in writing to Lanco® within 30 days after you have discovered an alleged leak.
Within a reasonable time after proper notification and validation of your claim, Lanco® will provide, free of
charge, enough roof sealer to recoat the affected area. This limited warranty is the exclusive and sole remedy
available to the purchaser. What is not covered by this warranty?: Lanco® does not warrant and shall not be
liable for damages arising out of purchaser's failure to apply the roof coating in accordance with our
instructions, disasters such as fire, flood, wind, lightning, structural defects and acts or causes beyond our
control, including the negligence of any person and any other abuse or misuse of the product by purchaser.
This warranty does not include labor or the cost of labor for the application of any roof coating. There are no
warranties which extend beyond the description on the face hereof. This warranty gives you specific legal
rights, and you may also have other rights which may vary from state to state. This Warranty does not apply to
commercial jobs, for these purposes call Lanco at 407-240-4000.
Keep original receipts.
Corporate Office & Manufacturing Plant: 600 Mid Florida Drive • Orlando, FL 32824
Toll Free: 1-866-447-2400 • 407-240-4000 • Fax: [phone]