SDS

RC-1062 - SILICONIZER 1000 ROOF COATING WHITE
Safety data sheet
according to 29 CFR 1910.1200
SECTION 2: HAZARD(S) IDENTIFICATION (continued)
Non-applicable
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
3.1
Substances:
Non-applicable
3.2
Mixtures:
Chemical description:
Silicone-based mixed solvent
Components:
Remaining components are non-hazardous and/or present at amounts below reportable limits. The specific chemical identity
and/or exact percentage (concentration) of composition has been withheld as a trade secret in accordance with paragraph (i) of
§1910.1200.Therefore, in accordance with Appendix D to § 1910.1200, the product contains:
Identification
Chemical name/Classification
Concentration
CAS:
70131-67-8
Dimethylsiloxane, Hydroxy-terminated
50 - <75 %
CAS:
13463-67-7
Titanium dioxide
Carc. 2: H351 - Warning
10 - <25 %
CAS:
22984-54-9
Butan-2-one O,O´,O´´-(methylsilylidyne)trioxime
Eye Irrit. 2: H319; Skin Sens. 1B: H317; STOT RE 2: H373 - Warning
2.5 - <10 %
To obtain more information on the hazards of the substances consult sections 8, 11, 12, 15 and 16.
SECTION 4: FIRST-AID MEASURES
4.1
Description of necessary measures:
The symptoms resulting from intoxication can appear after exposure, therefore, in case of doubt, seek medical attention for
direct exposure to the chemical product or persistent discomfort, showing the SDS of this product.
By inhalation:
This product does not contain substances classified as hazardous for inhalation, however, in case of symptoms of intoxication
remove the person affected from the exposure area and provide with fresh air. Seek medical attention if the symptoms get worse
or persist.
By skin contact:
Remove contaminated clothing and footwear, rinse skin or shower the person affected if appropriate with plenty of cold water
and neutral soap. In serious cases see a doctor. If the product causes burns or freezing, clothing should not be removed as this
could worsen the injury caused if it is stuck to the skin. If blisters form on the skin, these should never be burst as this will
increase the risk of infection.
By eye contact:
Rinse eyes thoroughly with water for at least 15 minutes. If the injured person uses contact lenses, these should be removed
unless they are stuck to the eyes, as this could cause further damage. In all cases, after cleaning, a doctor should be consulted
as quickly as possible with the SDS of the product.
By ingestion/aspiration:
In case of consumption, seek immediate medical assistance showing the SDS of this product.
4.2
Most important symptoms/effects, acute and delayed:
Acute and delayed effects are indicated in sections 2 and 11.
4.3
Indication of immediate medical attention and special treatment needed, if necessary:
Non-applicable
SECTION 5: FIRE-FIGHTING MEASURES
5.1
Suitable (and unsuitable) extinguishing media:
Product is non-flammable under normal conditions of storage, manipulation and use. In the case of inflammation as a result of
improper manipulation, storage or use preferably use polyvalent powder extinguishers (ABC powder), in accordance with the
Regulation on fire protection systems. IT IS NOT RECOMMENDED to use full jet water as an extinguishing agent.
Page 2/9
Date of compilation: 7/16/2019 Revised: 2/13/2020 Version: 3 (Replaced 2)
- CONTINUED ON NEXT PAGE -