Use and Care Manual

Uses:
Aqua-Proof™ Wall can be a main
waterproofing or part of a system for preparing
affected surfaces to be painted. It can be used
under or over stained as a moisture barrier or
waterproofing in an underground application
system. It should always be protected from UV
rays. Works as protection in wet areas such as
exterior or interior walls, bathrooms, kitchens,
balconies and basements. To apply in concrete,
metal, wood.
Notice: The technical data contained herein are
true and accurate to the best of our knowledge.
Published technical data and instructions are
subject to change without prior notice.
S.D.S.: Available upon request.
Concrete surfaces: Repair concrete holes or areas where concrete has been
weakened or stripped. Cover the area to be repaired with Lanco
®
Bonding
Agent and allow to dry. In addition, add one gallon of Lanco
®
Bonding Agent
to the mix for every 50 pounds of cement. Apply and let cure for a week.
Application Method:
Apply with a Lanco
®
3/4 "Nap Rough Roller or airless spray gun. Wait 24
hours between the layers to dry well. Apply only at temperatures above 50
o
F,
do not apply if the temperature is expected to fall below 50
o
F. Apply a second
coat if necessary to obtain the recommended thickness. Never dilute or mix
this product, use as it is in the container.
Recommended Equipment: Use a airless pump with a pressure between
1,500 and 2,000 psi. An application of 1 to 2 gallons per minute with a tip
from 0.026 to 0.035 is adequate. Wait 24 hours between coats. The hoses
should be 3/8" in diameter and the type used for high pressure. The inside
diameter will have to be greater if the hose is more than 50 feet long.
Cleaning: Clean all equipment with warm water and soap.
Danger/Warning:
Limited Warranty: Manufacturer's liability in connection with the sale of this
product will be extended to replacement price only if it fails to meet quality
standards or specifications and if application specifications are followed.
Caution: Contains 100% acrylic resin. In case of contact, the product may
cause eye, skin, nose and throat irritation. Immediately pour water. Do not
rub your eyes. In case of contact with skin, wash immediately with water. If
swallowed do not induce vomiting. Seek immediate medical attention. Keep
out of the reach of children.
Warning! If you scrape, sand or remove old paint, you can release lead dust.
Lead is toxic. Exposure to lead dust can cause serious illness, such as brain
damage, especially in children. Pregnant women should avoid exposure.
Use a NIOSH approved respirator to control lead exposure. Carefully clean
with a HEPA vacuum cleaner and a wet map. Before you begin, learn how to
protect yourself and your family by contacting the National Hot Lead
Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. For
chemical emergencies call ChemTrec 1-800-424-9300. Protect from
freezing.
• NORTH AMERICA • 600 Mid Florida Drive Airport Industrial Park of Orlando, Florida 32824 • Tel. [phone] Fax [phone]
• CARIBBEAN & SOUTH AMERICA • Urb. Aponte #5, San Lorenzo, Puerto Rico USA 00754 • Tel. [phone] Fax [phone]
• CENTRAL AMERICA • Zona Industrial Bes, lote #4, El Coyol de Alajuela, Costa Rica • Tel. [phone] Fax [phone]
Page 2 Aqua-Proof™ Wall MD-858 Rev. 06 / 2016