User's Manual
Table Of Contents
I
Troubleshooting
If your
Lam
bot does not
work
as
expected, its power button will light up with quick
red
flash.
Please
check the
following table or follow the instructions
in
Lam
bot mobile application for solutions.
No.
Exception
Message
Solution
1 Lidar error.
The
Lidar
gets
stuck or
obscured.
Please
remove
the
obstacles,
put
Lam
bot
back
on
the charging station
and
relaunch
it.
2 Impact sensor error.
The
impact
sensor
gets
stuck.
Please
pat
the impact
bar
several
times to
recover
its position.
Move
Lam
bot to a different
place
and
relaunch
it.
3
Wall-following sensor error.
Please
clean
the
surface
of the wall-following sensorto
ensure
there
is
no
dust or dirty stuff
on
it.
4
Lam
bot
is
lifted up.
Please
make
sure
the ground
is
level
and
remove
the obstacles that lift
Lam
bot. If the error still
exists,
please
clean
the
cliff
sensors
in
the bottom of
Lam
bot.
5 Cliff sensor error.
Please
clean
the cliff
sensors
in
the bottom of
Lam
bot.
6 Dust bin error.
Please
clean
the dust
bin
and
make
sure
that it
is
installed properly.
7 Side brush error.
Please
take
the
side
brushes
down,
clean
the tangled stuff
on
them
and
then reinstall them properly.
8
Main brush error.
Please
take
the main
brush
down,
clean
the tangled stuff
on
it
and
then reinstall
it
properly.
9 Wheel error.
Please
check
whether the
wheels
get
stuck
by
some
stuff.
Please
remove
the stuff
and
then
relaunch
Lam
bot.
10
Lam
bot
is
getting stuck.
Please
clean
the obstacles that hindered
Lam
bot,
move
Lam
bot to a different
place
and
relaunch
it.
11
Low battery.
Lam
bot
gets
low battery.
Please
take
it
back
to the charging station to fully
recharge
itself.
12
Battery error.
Lam
bot cannot work properly due to
extreme
battery temperature.
Please
retry after the battery temperature
recovers
to
normal.
13
Vacuum fan error.
The
vacuum
fan
cannot work properly.
Please
clean
the dust
bin
and
the filter,
and
then
relaunch
Lam
bot.
14 WiFi connection fail.
Please
check
whether the
WiFi
user
name
and
password
are
correct,and
make
sure
SSID
is
working
in
2.4G
mode.
Take
Lam
bot
and
smart
phone
close
to
the
Router
when
setting the network.
23