Operation Manual

- 2 -
Product installation
1) Connect the power cable to the cigarette lighter. Ensure the cable is placed around the windscreen so as not to
obstruct the driver‘s view and then x it securely in place. Attach thedevice between the glass and the mirror.
This will give you the optimal picture.
2) Do not install in a position which obstructs the driver‘s view or distracts them.
3) Some vehicles continue to supply power to the cigarette lighter, even when the engine is turned o. In this
case, before leaving the vehicle, unplug the cable from the cigarette lighter.
4) When using the device for the rst time, the battery may be low. If you cannot switch on the device due to low
power, manually connect the external power cable to charge the battery.
5) Use only a high-quality micro SDHC card of class 10 or higher. For optimal recording use, we recommend cards
with a capacity of at least 8GB up to a maximum of 32GB. If this is the rst use of the card, we recommend
formatting it rst.
Quick functions
1) LED light – tap the UP arrow to switch between ON/OFF/Auto.
2) Parking mode – tap the „PARKING MODE“ button.
3) ON/OFF LCD – tap the DOWN arrow.
4) Lock/unlock le – le can be lock/unlock during recording by tap MODE button.
5) Timelapse – for ON/OFF timelapse pushand hold red button (P) at least for two seconds.
Icons annotation
DISPLAY
Mem card not detected LED light OFF
Mem card detected LED light ON
Battery status LED light Auto
Video Mode Exposure Value
Photo Mode Motion Detection
Video Resolution Parking Mode
File locked Timelapse
DISPLAY: White Balance
White Balance – Auto White Balance – Fluorescent
White Balance – Daylight White Balance – Tungsten
White Balance – Cloudy