Operation Manual

- 2 -
Product installation
1) Connect the power cable to the cigarette lighter. Ensure the cable is placed around the windscreen so as not to
obstruct the driver‘s view and then x it securely in place. Attach the device on the rear-view mirror by rubber
bands. This will give you the optimal picture.
2) Attach back camera with 3M stickers on rear window.
3) Connect back and front camera using A/V cabel (connector 8). Place the cable along the chassis of the car,
nowhere to obstruct to avoid any damage during vehicle operation.
4) Some vehicles continue to supply power to the cigarette lighter, even when the engine is turned o. In this
case, before leaving the vehicle, unplug the cable from the cigarette lighter.
5) When using the device for the rst time, the battery may be low. If you cannot switch on the device due to low
power, manually connect the external power cable to charge the battery.
6) Use only a high-quality micro SDHC card of class 10 or higher. For optimal recording use, we recommend cards
with a capacity of at least 8GB up to a maximum of 32GB. If this is the rst use of the card, we recommend
formatting it rst.
Quick functions
1) Switching between front and back camera – tap arrow LEFT
2) Turn o the display – tap the ON/OFF button
3) File lock – when recording video, lock the current recording by tapping the “MODE” button.
4) Delete le – tap the MENU button in„gallery“ mode.
Icons annotation
Battery status Battery is charging
P
Parking mode Track recording
Motion detection
Mem card detected
Mem card not detected
Sound On Sound O
Using the LAMAX DRIVE C5 Dual car camera
1) Inserting a micro SDHC card
Insert or remove the micro SDHC card from the card slot only when the camera is turned o and not connected
to a computer or power supply.
2) Power
a) Camera can be powered using a USB cable connected to a computer or using the car cigarette lighter.
b) Camera is designed to be powered continuously. Built-in battery can not be removed or replaced.
c) Integrated battery is primarily for use in parking mode.
3) Turning the camera on and o
a) To switch on the camera, press and hold the ON/OFF button for 3-5 seconds.
b) Cameras automatically turns on when connected to a power supply.
c) To switch o the camera, press and hold the ON/OFF button for 3-5 seconds.
d) Camera automatically turns o after disconnecting the power supply.