Instructions / Assembly

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to
the store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems di-
rectly for you.
CF400/CF500 CEDAR LOG A-FRAME
A-FRAME COMPONENTS
1 - Top Rail
4 -Legs
6 - Braces
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered de-
fects.
A-FRAME HARDWARE
(Shown smaller than actual size)
2 - 8”
Bolts
2 - 1/2”
Nylock Nuts
2 - 3/8”
Nuts
2 - 1/2” x 6”
Eye Bolts
12 - 1/4” x 3”
Hex Washer
Head Screws*
4 - 1/2” Washers
* Lag Screws and
Washers may be
substituted for
Hex Washer
Head Screws
4 - 3/8” Washers
 3/4” deep well
socket
 9/16 deep well
socket
 9/16” wrench
 7/16” socket or
wrench
 3/8” socket or
wrench
 Power Drill
Tools that May Be Needed
Hammer
Tape Measure
Pencil
TIPS
 A battery operated or electric drill will
make
 assembly faster and easier.
 Use a good quality penetrating oil or wood
deck sealer with a UV inhibitor & an anti-
fungal. (Make sure product is intended for
outdoor use.)
 Read all instructions before
starting.
 To start hex washer head screws, hammer into
wood about 1/2” then use wrench or socket to
tighten.
 Do not completely tighten any screws until the
unit is fully assembled and setting on a level
surface.
 If you have hardware left over after completing
your unit, it most likely has been assembled in-
correctly, and may not be safe to use. Please
call Customer Service at 1-800-427-5136, for
assistance.
 Check all nuts and bolts for tightness before
and during each usage season.
NOTE:
Look for videos on:
https://www.youtube.com/watch?
v=Iqul3dHxNMo
https://www.youtube.com/watch?v=-OmqxSrmkYM