Manualshelf

Quick Start Guide

ManualsBrandsLake ManualsEffects and Signal ProcessorsAudio System Processor with Raised Cosine EQ and Simultaneous Cross-Platform Parameter Adjustments for Loudspeaker Management and System Control in High-Performance Applications
11121314151617181920
4. Product overview
LM SERIES Quick Start Guide rev 1.3.6
13
Use the primary connector when using a star network topology, consisting of individual Cat-5e connections
between the devices and an Ethernet switch. Alternatively this connection can be used to daisy chain directly to
another LAKE Processor. The daisy chain topology should not be used with Dante.
For a technical reference of the Ethernet Port, please refer to section 7.3 of the LM Series Operation Manual.
Additional information is also available in the LAKE Network Conguration Guide.
NOTE: The Ethernet ports automatically switch to operate at Ethernet data rates of 100 Mbps or 1000
Mbps, and allow straight or crossed network cables. Two LEDs above each port indicate valid network
connection (LINK) and network activity (ACT).
5
Secondary Connector - The secondary network connector can be used to daisy-chain multiple LM & PLM
Series and legacy Dolby and LAKE devices. Alternatively, a Dante dual-network topology can be created by
connecting all secondary network connectors to a separate Ethernet switch, ensuring full redundancy in the event
of a network component failure.
NOTE: Additional processor conguration is required for a dual redundant network setup. See the
LAKE Controller Operation Manual for further details.
For a technical reference of the Ethernet Port, please refer to section 7.3 of the LM Series Operation Manual.
Additional information is also available in the LAKE Network Conguration Guide.
NOTE: When connecting multiple devices to an Ethernet network, care must be taken NOT to create a
closed loop which causes network malfunction.
6
GPIO Connector - A 9-pin GPIO (General Purpose Input Output) connection is provided to enable integration
with external systems such as alarm/re systems, providing basic control of power state, mute along with fault
notication to an external monitoring system. Please refer to sections 6.9.4.4 and 7.4 of the LM Series Operation
Manual for further details.
7
Mains Power Connector - A universal power supply capable of accepting 70-265 V ~ 50-60 Hz : 25 W is
built into LM Series devices. The IEC power cable provided includes a locking feature via a pin on the bottom of the
connector; the connector can accept standard or locking IEC power cables.
The power supply must be connected to AC mains using a power cable with a correctly wired plug for the
country of operation.