User's Manual
Table Of Contents
- FEATURES
- APPLICATIONS
- DESCRIPTION
- ORDERING INFORMATION
- MODULE ACCESSORIES
- BLOCK DIAGRAM
- FUNCTIONAL BLOCK FEATURES
- TIWI-SL MODULE FOOTPRINT AND PIN DEFINITIONS
- PIN DESCRIPTIONS
- ELECTRICAL SPECIFICATIONS
- DEVICE POWER-UP AND ENABLE
- SPI HOST-CONTROLLER INTERFACE
- SOLDERING RECOMMENDATIONS
- CLEANING
- OPTICAL INSPECTION
- REWORK
- SHIPPING, HANDLING, AND STORAGE
- AGENCY CERTIFICATIONS
- AGENCY STATEMENTS
- OEM RESPONSIBILITIES TO COMPLY WITH FCC AND INDUSTRY CANADA REGULATIONS
- OEM LABELING REQUIREMENTS FOR END-PRODUCT
- OEM END PRODUCT USER MANUAL STATEMENTS
- MECHANICAL DATA
- DEVICE MARKINGS
- CONTACTING LS RESEARCH
TiWi-SL MODULE
DATASHEET
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
330-0085-R0.4 Copyright © 2011 LS Research, LLC Page 29 of 36
Industry Canada Statements
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for
successful communication.
This device has been designed to operate with the antenna(s) listed below, and having a maximum
gain of 4.3 dBi (LSR Dipole) and 1.3dBi (Johanson Chip). Antennas not included in this list or having a
gain greater than 4.3 dBi and 1.3dBi are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
List of all Antennas Acceptable for use with the Transmitter
1) LS Research 001-0001 center-fed dipole antenna and LS Research 080-0001 u.fl to Reverse Polarity
SMA connector cable.
2) Johanson 2450AT43B100 chip antenna.
L'opération est soumise aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement de l'appareil.
Pour réduire le risque d'interférence aux autres utilisateurs, le type d'antenne et son gain doiventêtre
choisis de manière que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pascelle
permise pour une communication réussie.
Cet appareil a été conçu pour fonctionner avec l'antenne (s) ci-dessous, et ayant un gain maximum de
4,3 dBi (LSR dipôle) et1.3dBi (Chip Johanson). Antennes pas inclus danscette liste ou d'avoir un gain
supérieur à 4,3 dBi et-1.3dBi sont strictement interdites pour l'utilisation avec cet appareil. L'impédance
d'antenne requise est de 50 ohms.
Liste de toutes les antennes acceptables pour une utilisation avec l'émetteur
1) LS Research 001-0001 alimenté par le centre antenne dipôle et LS Research 080-0001
U.FL d'inversion de polarité du câble connecteur SMA.
2) Antenne Johanson puce 2450AT43B100.