User Manual

TiWi-R2 TRANSCEIVER MODULE

DATASHEET

The information in this document is subject to change without notice.

WLAN POWER-DOWN SEQUENCE

Notes:

1. The DC2DC(1.8V) signal can be monitored on BT_FUNC2 Module Pin (#41)

2. DC_REQ and CLK_REQ are internal signals shown for reference only

Figure 4 TiWi-R2 Module Power-down Sequence Requirements

1. DC_REQ will go low only if WLAN is the only core working. Otherwise if another core is working (e.g

BT) it will stay high.

2. CLK_REQ will go low only if WLAN is the only core working. Otherwise if another core is working and

using the F

REF

(e.g BT) it will stay high.

3. If WLAN is the only core that is operating, WL_EN must remain de-asserted for at least 64sec

before it is re-asserted.