User's Manual

SiFLEX01 TRANSCEIVER MODULE

DATASHEET

The information in this document is subject to change without notice.

End Product Labelling

The SiFLEX01 Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and

IC Certification Number are not visible when the module is installed inside another device, then the

outside of the device into which the module is installed must also display a label referring to the

enclosed module. In that case, the final end product must be labeled in a visible area with the

following:

“Contains Transmitter Module FCC ID: TFB-SISEN1”

“Contains Transmitter Module IC: 5969A-SISEN1”

“Contains FCC ID: TFB-SISEN1”

“Contains IC: 5969A-SISEN1”

The OEM of the SiFLEX01 Module must only use the approved antenna(s) listed above, which have

been certified with this module.

The OEM integrator has to be aware not to provide information to the end user regarding how to install

or remove this RF module or change RF related parameters in the user manual of the end product.

The user manual for the end product must include the following information in a prominent

location:

This device is granted for use in Mobile only configurations in which the antennas used for this

transmitter must be installed to provide a separation distance of at least 20cm from all person

and not be co-located with any other transmitters except in accordance with FCC and Industry

Canada multi-transmitter product procedures.