User's Manual
Table Of Contents
- FEATURES
- APPLICATIONS
- DESCRIPTION
- ORDERING INFORMATION
- MODULE ACCESSORIES
- BLOCK DIAGRAM
- DEVELOPMENT KIT
- MODULE PINOUT AND PIN DESCRIPTIONS
- MODULE OVERVIEW
- OPERATING MODES TRUTH TABLE
- MODES OF OPERATION
- DEVELOPMENT TOOLS
- ELECTRICAL SPECIFICATIONS
- SOLDERING RECOMMENDATIONS
- CLEANING
- OPTICAL INSPECTION
- REWORK
- SHIPPING, HANDLING, AND STORAGE
- AGENCY STATEMENTS
- MECHANICAL DATA
- COMPATIBILITY
- MODULE REVISION HISTORY
- CONTACTING LS RESEARCH
SiFLEX02-HP TRANSCEIVER MODULE
DATASHEET
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
330-0047-R0.7 Copyright © 2010-2011 LS Research, LLC Page 30 of 35
End Product Labelling
The SiFLEX02-HP Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID
and IC Certification Number are not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the
following:
“Contains Transmitter Module FCC ID: TFB-SIFLEX2HP”
“Contains Transmitter Module IC: 5969A-SIFLEX2HP”
or
“Contains FCC ID: TFB-SIFLEX2HP”
“Contains IC: 5969A-SIFLEX2HP”
The OEM of the SiFLEX02-HP Module must only use the approved antenna(s) listed above, which
have been certified with this module.
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module or change RF related parameters in the user manual of the end product.
The user manual for the end product must include the following information in a prominent
location:
This device is granted for use in Mobile only configurations in which the antennas used
for this transmitter must be installed to provide a separation distance of at least 20cm
from all person and not be co-located with any other transmitters except in accordance
with FCC and Industry Canada multi-transmitter product procedures.