User's Manual

Table Of Contents

SiFLEX02-HP TRANSCEIVER MODULE

DATASHEET

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.

OEM Responsibilities to comply with FCC and Industry Canada Regulations

The SiFLEX02-HP Module has been certified for integration into products only by OEM integrators

under the following conditions:

This device is granted for use in Mobile only configurations in which the antennas used for this

transmitter must be installed to provide a separation distance of at least 20cm from all person and not

be co-located with any other transmitters except in accordance with FCC and Industry Canada multi-

transmitter product procedures.

As long as the two conditions above are met, further transmitter testing will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC peripheral

requirements, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met (for certain

configurations or co-location with another transmitter), then the FCC and Industry

Canada authorizations are no longer considered valid and the FCC ID and IC Certification

Number cannot be used on the final product. In these circumstances, the OEM integrator

will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC and Industry Canada authorization.