User's Manual

Table Of Contents

SiFLEX02 TRANSCEIVER MODULE

MODULE USER’S GUIDE

• On board chip helical – Pulse Engineering W3112A

6.3 OEM Responsibilities to comply with FCC and Industry Canada

Regulations

The SiFLEX Module has been certified for integration into products only by OEM

integrators under the following conditions:

1. The antenna(s) must be installed such that a minimum separation distance of 20cm

is maintained between the radiator (antenna) and all persons at all times.

2. The transmitter module must not be co-located or operating in conjunction with any

other antenna or transmitter.

As long as the two conditions above are met, further transmitter testing will not be

required. However, the OEM integrator is still responsible for testing their end-product for

any additional compliance requirements required with this module installed (for example,

digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met

(for certain configurations or co-location with another transmitter),

then the FCC and Industry Canada authorizations are no longer

considered valid and the FCC ID and IC Certification Number cannot

be used on the final product. In these circumstances, the OEM

integrator will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC and

Industry Canada authorization.

6.4 End Product Labeling

The SiFLEX Module is labeled with its own FCC ID and IC Certification Number. If the

FCC ID and IC Certification Number are not visible when the module is installed inside

another device, then the outside of the device into which the module is installed must

also display a label referring to the enclosed module. In that case, the final end product

must be labeled in a visible area with the following:

“Contains Transmitter Module FCC ID: TFB-SiFLEX2”

“Contains Transmitter Module IC: 5969A-SiFLEX2”

“Contains FCC ID: TFB-SiFLEX2”

“Contains IC: 5969A-SiFLEX2”

The OEM of the SiFLEX Module must only use the approved antenna(s) listed above,

which have been certified with this module.

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.