User's Manual

Table Of Contents

SiFLEX02 TRANSCEIVER MODULE

MODULE USER’S GUIDE

5.5.1 Constructing an alignment fixture

Any carrier board can be made into an alignment fixture. When using the carrier board

as an alignment fixture the alignment pins can be soldered to the bare carrier board to

prevent them from falling out. Then by adding standoffs to the bare carrier board you

have created an alignment fixture.

Figure 13 Alignment fixture overview

Step 1: Make an alignment fixture by soldering two Mill-Max 3120-2 series pins or

equivalent into the PCB being used for the alignment fixture. For spacing, use 1/8”

standoffs between this board and the target carrier board.

Figure 14 Constructing an alignment fixture

Step 2: Carefully place the target carrier board through the pins on the alignment fixture.

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.