User's Manual

RAMP Bridge
Installation and Operations Guide
Embedded Wireless Solutions Support Center: http://ews-
support.lairdtech.com
www.lairdtech.com/wireless
3
Laird Technologies
Americas: [phone]
Europe: [phone]
Hong Kong: [phone] x026
FCC Statements of Conformity
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT NOTE: Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The table below indicates the recommended minimum distances of operation from the human body as shown from the MPE
(Maximum Permissible Exposure) calculation:
Minimum Distance
General Public/Uncontrolled Exposure
Minimum Distance
Occupational/Controlled Exposure
50 cm (20 inches)
22 cm (9 inches)
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada Statements of Conformity
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement
est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout
brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
IMPORTANT NOTE: Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The table below indicates the recommended minimum distances of operation from the human body as shown from the MPE
(Maximum Permissible Exposure) calculation:
Minimum Distance
General Public/Uncontrolled Exposure
Minimum Distance
Occupational/Controlled Exposure
50 cm (20 inches)
22 cm (9 inches)