User's Manual

LoRa/BLE Modules
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
7
© Copyright 2016 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Categories
Feature
Implementation
From 1,200 to 460800 bps
GPIO
Up to 14
With configurable I/O direction, O/P drive strength
(standard 0.5 mA or high 5 mA), pull-up/pull-down
ADC
Four 10-bit channels (including ADC reference)
10 bit resolution
1.2 V internal reference
1/1, 2/3, 1/3 pre-scaling
PWM or FREQ output
PWM or FREQ output on up to two GPIO output pins:
PWM output duty cycle
0%-100%
PWM output frequency
Up to 500 kHz (Note 7)
FREQ output frequency
0 MHz-4 MHz
(50% duty cycle)
I2C
One I2C interface (up to 400 kbps) (Note 2)
SPI
One SPI Master interface (up to 4 Mbps) (Note 3)
Services
Services supported
GATT client and capabilities
FW Upgrade
smartBASIC runtime engine FW
upgrade
(1) Via UART
(2) Via 2-Wire SWD Programming/Debug Interface
Programmability
smartBASIC
On-board programming language similar to BASIC.
smartBASIC application
download
(1) Via UART.
(2) Via 2-Wire SWD Programming/Debug Interface
Control Protocols
Any
User defined via smartBASIC
Operating Modes
Self-contained Run mode
Selected by nAutoRun pin status:
nAutoRun = LOW (0V): Then runs $autorun$
(smartBASIC application script) if it exists.
Interactive / development
mode
nAutoRun = HIGH (VCC): Then runs via at+run (and
“file name” of smartBASIC application script).
Supply Voltage
Supply (VCC)
2.1V – 3.5V
Internal DCDC converter (Note 5)
1.8V – 2.1V
Internal LDO
DCDC switched on if VCC >2.1V at power-up
Power Consumption
Active modes peak current
(for Max TX PWR 3 dBm)
Connected mode
11.6 mA peak TX
8.9 mA peak RX
Active modes peak current
(for TX Whisper mode2 PWR -
55 dBm)
Connected mode
5 mA peak TX
8.5 mA peak RX
Active modes average current
Depends on many factors. See Power Consumption.
Ultra-low power modes
Standby Doze
Deep Sleep
2.6 uA typical (Note 6)
600 nA (Note 6)
Antenna Options
BLE (Internal) chip antenna
On-board ceramic chip monopole antenna
-1.5 dBi
LoRa (External)
Dipole antenna with U.FL (IPEX) connector up to 2 dBi