User Manual

ProFLEX01 TRANSCEIVER MODULE

MODULE USER’S GUIDE

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.

4.4 End Product Labeling

The ProFLEX01 Module is labeled with its own FCC ID and IC Certification Number. If

the FCC ID and IC Certification Number are not visible when the module is installed

inside another device, then the outside of the device into which the module is installed

must also display a label referring to the enclosed module. In that case, the final end

product must be labeled in a visible area with the following:

“Contains Transmitter Module FCC ID: TFB-PROFLEX1”

“Contains Transmitter Module IC: 5969A-PROFLEX1”

“Contains FCC ID: TFB-PROFLEX1”

“Contains IC: 5969A-PROFLEX1”

The OEM of the ProFLEX01 Module must only use the approved antenna(s) listed

above, which have been certified with this module.

The OEM integrator has to be aware not to provide information to the end user regarding

how to install or remove this RF module or change RF related parameters in the user

manual of the end product.

The user manual for the end product must include the following information in a

prominent location:

To comply with FCC and Industry Canada RF radiation exposure limits for

general population, the antenna(s) used for this transmitter must be

installed such that a minimum separation distance of 20cm is maintained

between the radiator (antenna) and all persons at all times and must not

be co-located or operating in conjunction with any other antenna or

Revision History