User's Guide

PRO-FLEX TRANSCEIVER MODULES

USER’S GUIDE

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.

Figure 4 PER Test Transmitter RF Settings

On the PERT tab, configure these test settings, as shown in Figure 5:

Test Mode

 Tx Mode – Board is transmitter

 Rx Mode – Board is receiver

Options

 Send Results after test – results are sent back to host only after test is completed.

 Send Results every second – results are sent back to host on a 1s periodic basis. This is the

preferred option for the test tool, because you get instant feedback that the test is working

and how well it is working.

OTA Data

 User defined – user can enter ASCII data to be transmitted. When this is selected the

“Number of Bytes to Transmit” is hidden. This is not shown below.

 Pre defined – sequential data starting at 1 and ending at Number of Bytes to Transmit is sent.

 In either case the prefix for this data is amended.