User's Guide

PRO-FLEX TRANSCEIVER MODULES
USER’S GUIDE
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
PFLX-UG-0002-00-17 Copyright © 2009 LS Research, LLC Page 6 of 29
2.6.1 Receiver Setup
Setup a board as a receiver with these settings, for example, as shown in Figure 2:
 Short Address: 200
 Pan ID: 111
 RF Channel: 20
 Tx Power: 0
Figure 2 PER Test Receiver RF Settings
Test Mode
 Tx Mode – Board is transmitter
 Rx Mode – Board is receiver
Options
 Send Results after test – results are sent back to host only after test is completed.