User's Guide

PRO-FLEX TRANSCEIVER MODULES

USER’S GUIDE

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.

7 Agency Statements

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause

undesired operation.

FCC/IC Caution

: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

OEM Responsibility to the FCC Rules and Regulations

The Pro-FLEX Module has been certified per FCC Part 15 and IC RSS-GEN (2007) rules for

integration into products without further testing or certification. To fulfill the FCC and IC

certification requirements the OEM of the Pro-FLEX Module must ensure that the information

provided on the Pro-FLEX Label is placed on the outside of the final product.

The Pro-FLEX Module is labeled with its own FCC ID and IC Number. If the FCC ID and IC

Number are not visible when the module is installed inside another device, then the outside of

the device into which the module is installed must also display a label referring to the enclosed

module. The final end product must be labeled in a visible area with the following:

“Contains Transmitter Module FCC ID: TFB-PROFLEX1”

“Contains Transmitter Module IC: 5969A-PROFLEX1”

“Contains FCC ID: TFB-PROFLEX1”

“Contains IC: 5969A-PROFLEX1”