User's Guide

PRO-FLEX TRANSCEIVER MODULES

USER’S GUIDE

The information in this document is subject to change without notice.

Confirm the data is current by downloading the latest revision from www.lsr.com.

While in the ping pong mode, the current channel can be changed to one of four other

unique channels (four channels total). This is accomplished by holding the User Button

for approximately two seconds, at which point the yellow LED will be lit steady. Once

the push button is released, the current channel option number (one through four) is

displayed by a series of flashes on the red LED. Each short push button press will

increment the channel option number and display it with a given number of flashes on

the red LED. To accept the last selected channel, hold the push button until the green

LED goes out (approximately two seconds). After again releasing the button, the device

will return to the ping pong mode.

Note that both the master and slave devices must be set to the same

channel option number for the pair to communicate, and each board must

be individually set to that given channel option number.