User's Guide

PRO-FLEX TRANSCEIVER MODULES
USER’S GUIDE
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
PFLX-UG-0002-00-17 Copyright © 2009 LS Research, LLC Page 10 of 29
o OTA packet type – 0x71 (1 byte)
o Current Message Number (0-65535) two bytes
o Total Number of Messages (0-65535) two bytes
Query / Cancel
 Sends out Host Message Type 0x43.
 PERT Test in Tx will end in one of two ways:
o 100% of packets are transmitted
o Host cancel
 If cancel is selected it will cancel the current test
 “PERT In-Progress” is filled in based on query results. Red = no test in progress, green =
test in progress
Setup Packet Error Rate Test
 Dest Transceiver Address: 200 (who message is being sent to)
 Number of Packets: 100 (number of RF packets (5-65535)
 Time between Packets: 20 (in terms of 5mS ticks. A selection of 5 would sent out packets
every 5x5mS or 25mS). Range is 1-255.
 Number of Bytes: 30 (number of user bytes in packet. Range is 1-105)
Packet Error Rate Results
 Filled in when results are received based on options above
 The PERT Completion uses the number of packets sent/total number of packets to calculate
how far into the test we are.
 LQI Average and PERT Success are grayed out because they are N/A on the TX side