User Manual

PRO-FLEX SERIES TRANSCEIVER MODULES
HOST PROTOCOL GUIDE
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision of this document from www.lsr.com.
PFLX-UG-0001-00-09 Copyright © 2009 LS Research, LLC Page 32 of 37
Host to
Module
Module
to Host
Allow
Remote
Message
Length
Payload
Length
Payload
Name
Description
3.2.49 Set Packet Error Rate Test Receive Configuration
0x41 11
2
Source
Transceiver
Address
Two byte source transceiver address (LSB to
MSB). This is the address of the transceiver
that is sending the message.
2
Number of
Packets to
Receive
LSB to MSB. Valid range is 5-65,535.
1
Number of
RF Bytes
Number of RF Bytes to expect (1-105).
Should match length n in Message Type
0x40.
1
Send
Ongoing
Results
This field determines if the receive test
results will be transmitted to the host every
one second.
0 = Results not automatically sent.
1 = Results sent every one second.
0xC1 5 -
3.2.50 Packet Error Rate Packet Results
When in either transmit or receive PERT mode, and the options field was set to send results every second, this
message will be sent every second to the host device.
N/A
0xC2 16
1 Test Mode
0 = Transmit mode.
1 = Receive mode.
2
Packets
Transmitted/
Received
This is the number of packets (LSB to MSB)
that have either been transmitted or received,
based on the Test Mode above.
2
Total
Number
Packets
This is the total number of packets that were
supposed to be received based on Message
Type 0x41. Sent LSB to MSB. Valid range
is 5-65,535.
PERT Success = Number of Packets
Received/Total Number of Packets.