Users Manual Part 1

Nerve Integrity Monitor

Standard Clamping

Monopolar and Bipolar (if needed) Clamping

Note: Bipolar clamping is normally not needed, but if power level is very low it may be necessary to loop the single conductor

around and through the clamp. Refer to step 6 for clamping instructions.

5. Slide the cable so the probe is near the main unit of the electrosurgical instruments, not near the hand piece(s).

6. Slip the upper side of the anti-slide ring around the end of the Muting Detector to form a “U” around the cable. Pull it snugly

against the probe’s lower jaws (see Steps 1 & 2).

Step 1 Step 2

Note: Do not clip the Muting Detector to the grounding pad cable.

7. Secure the Muting Detector and Patient Interface cables to the oor with tape or other non-slip/trip device.

8. If necessary, for very low power levels, loop the single conductor around and through the clamp once.

FCC use only, not for Medical use