Users Manual Part 1
50
Nerve Integrity Monitor
Monopolar probe and Stimulus Dissection probe
1
2
3
4
5
6
7
8
1 Negative Electrode Jacks (electrode plug matches
color and wire is black)
2 Positive Electrode Jacks (electrodes, plug and wire
are the same color)
3 Paired Electrodes
4 STIM2 Stimulator Return (anode)
5 Stimulator Output, Monopolar Probe with Universal
Handle (cathode)
6 Stimulator Output, Stimulus Dissection Probe and
Cable (cathode)
7 STIM 1 Stimulator Return (anode)
8 Electrode Ground
Bipolar and Monopolar probe
1
2
3
4
5
6
7
8
9
1 Stimulator Output, Monopolar Probe with Universal
Handle (cathode)
2 Bipolar Probe and Handle.
Note: By default Monopolar (STIM 1 and STIM 2) is
selected on the Type Panel (located in the Settings/
Stimulation Panel). The operator should change this to
Bipolar.
3 Negative Electrode Jacks (electrode plug matches
color and wire is black)
4 Positive Electrode Jacks (electrodes, plug and wire are
the same color)
5 Paired Electrodes
6 STIM1 Stimulator Return (anode)
7 Stimulator Output (cathode)
8 Electrode Ground
9 STIM2 Stimulator Return (anode)
For installing the stimulating electrode
Refer to the Instructions for Use included with your electrode set.
FCC use only, not for Medical use