User's Manual

Laird MSD45N
Hardware Integration Guide, version 0.04
Americas: [phone] Option
3
Europe: [phone]
Hong Kong: [phone] x026
www.lairdtech.com/wireless
21
Laird Technologies
This device is intended only for OEM integrators under the following conditions:
 The antenna must be installed such that 20 cm is maintained between the antenna
and users, and
 The transmitter module may not be co-located with any other transmitter or antenna,
 For all products marketed in the United States, the OEM must limit the operation
channels from CH1 to CH11 for 2.4 GHz band by the supplied firmware programming
tool. The OEM shall not supply any tool or information to the end-user regarding
Regulatory Domain change.
As long as the three conditions above are met, further transmitter testing is not required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example, certain
laptop configurations or co-location with another transmitter), then the
FCC authorization is no longer considered valid and the FCC ID cannot
be used on the final product. In these circumstances, the OEM integrator
is responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna is installed such
that 20 cm is maintained between the antenna and users. The final end product must be
labeled in a visible area with the following: “Contains FCC ID: SQG-MSD45N”.
Manual Information to the End User
The OEM integrator may NOT provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warnings as show in this
Hardware Integration Guide.
Industry Canada
Note: You must place “Contains IC : 3147A-MSD45N” on the host product in such a location
that it can be seen by an operator at the time of purchase.
User’s Guide Requirements (for Model # MSD45N)
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device
must be installed in a location where the antennas of the device will have a minimum distance
of at least 20 cm from all persons. Using higher gain antennas and types of antennas not
certified for use with this product is not allowed. The device shall not be co-located with another
transmitter.
Installez l'appareil en veillant à conserver une distance d'au moins 20 cm entre les é lé ments
rayonnants et les personnes. Cet avertissement de sé curité est conforme aux limites d'exposition
dé finies par la norme CNR-102 at relative aux fré quences radio.